Power flush sends a special cleaning solution through your central heating system under high pressure
It clears the harmful sludge which builds up over time as a result of the reaction between water and steel radiators
It revitalises older central heating systems and it definitely worth the investment if you are installing a new boiler otherwise its performance will always be less efficient than it should be
Then a power flush could help
Is the system slow to start
Are some radiators cold or partially cold
Do your radiators need bleeding all the time
Is the water dirty
Frequent pump failure
Kettling noises from the boiler
With corrosion within central heating systems accounting for 90% of all systems Boiler failures and to ensure maximum efficiency from your new boiler A.M.R plumbing and heating recommends power flushing
How it works
The pump is connected to your central heating system so that the high water velocity and instantaneous flow reversing device , dislodge and mobilise sludge and corrosion deposits having loosened the debris,the pump forcibly expels it through the system during the power flush,each radiator is individually flushed without having to disconnect it at the end of the flushing process,which takes between 2-5 hours ,your central heating system contains fresh water and inhibitor is added to prevent future corrosion
Side effects
Occasionally ,where corrosion is already evident, the process can expose a pin hole in a radiator that was being blocked by rust or debris
Benefits
0 Cures flow problems
0 Restore boiler 'kettling'
0 Often a requirement to extend boiler warranties and by
providers of central heating insurance cover
0 Restore heat output to radiators
The cost
Prices will very from system to system please contact us for a price